Nitecore NB10000 Review (10,000mAh, 18W USB-C, Carbon Fiber, Powerbank)

Today I have Nitecore’s newest powerbank the Carbon Fiber NB10000. It’s made from Carbon Fiber, all around, features 10,000mAh capacity, along with USB-C and A, and is capable of 18W input and output. Thanks to NitecoreStore for sending this to me to check out and review. 


Watch this review on YouTube: 

**Follow me on Instagram: 

Join the Facebook Page: 


Packaging & Accessories

Packaging here is quite nice it’s a box that looks like it’s made of carbon fiber and it’s a pull out tray that has the powerbank, included USB-A to C cable, and the paperwork inside. 




This powerbank is made from a carbon fiber reinforced plastic case, this is a more expensive stronger material then you find in most power banks. It feels a lot like a high quality tool that’s using a glass reinforced plastic. As for the carbon fiber on the top and bottom, I have my doubts here on it’s authenticity. When I hold it up at a certain angle and press near the front I can get it to deflect easily, there is also no texture in the weave that I can feel. At best it’s a peel and ply carbon fiber, at worst it’s a printed and stuck on. Other then that it’s quite stiff and feels well built. On one side all the inputs and outputs are laser engraved and easily read.

At the front you have one USB-A port for output only, up to 18W, then you have a USB-C port that can be used for In or out at 18W each. Next to it you have the single button on the powerbank with 3 blue LED underneath for power indication.

Oh and it’s water rated at IPX5 which is rare for a powerbank. It means it can sustain a low pressure jet of water or splashes, so it’s perfect for adventuring. Even though it’s not officially rated for it, I did submerge it briefly and it survived. 


Size and Weight

I measured it as 122mm long, 59mm wide, and 10.5mm thick. This is nice and thin and slides behind most modern smartphones in a pocket while charging which is convenient when traveling. At 151.2 Grams it’s pretty light too thanks to that use of carbon fiber.

When I compare it to my Aukey 10,000mAh powerbank the Aukey is wider, longer, and 43g heavier. The 10,000mAh Anker powerbank I have is shorter but significantly thicker, I suspect it’s using cylindrical cells (21700?) and is 41 grams heavier. 



As mentioned the NB10000 has one USB-A port for output only, up to 18W, then you have a USB-C port that can be used for In or out at 18W each.

I did my charging tests with my 65W Aukey GaN chargers that I previously reviewed on this channel and had no issues. Total charge time was 3:13:00. Peak charge I saw was 8.9V at 2.0A, or right at 18W. My CT-2 Meter recorded a total of 43.44Wh went into the battery. 


Official Specs are as follows

Input – USB-C: 5V @ 2.4A or 9V @ 2A

Output – USB-C: 5V @ 3A or 9V @ 2A or 12V @ 1.5A

  USB-A: 5V @ 3A or 9V @ 2A or 12V @ 1.5A

I ran 3 discharge tests, 5V at 3A, 9V at 2A, and 12V at 1.5A each performed as expected with power being pretty stable. 


At 5V at 3A, I measured total energy at 31.29Wh, and average voltage at 5.18V and a total discharge time of 2:01:05.


At 9V at 2A, I measured total energy at 29.16Wh, and average voltage at 9.14V and a total discharge time of 1:35:58.


At 12V at 1.5A, I measured total energy at 29.71Wh, and average voltage at 12.02V and a total discharge time of 1:38:58, with a bit of voltage step down the last 20 minutes.


The NB10000 also offers Passthrough Charging meaning you can connect it to your charger, via USB-C and then charge your phone or other device (Flashlight) via the USB-A port, and both will charge at once. It’s not the full 18W speed but for me both my phone and the powerbank were full in the morning, making this great for backpacking or travel.


I charged my good old Note 8 from 15% to 100% in 1:51:00 via USB-C with 2/3 lights lit on the powerbank. I charged my phone again from 50% to 100% and the powerbank was still showing ? full. 


It’s nice that the powerbank has a low power mode that you can activate by pressing and holding the single button until a white LED comes on underneath. This is perfect for charging an increasing number of low power devices like wireless headphones, smart watches and other wearables. 



  • Carbon Fiber! I am a sucker for carbon, real or fake it doesn’t matter.
  • Really small and compact
  • Supports 18W in or out, and charging via USB-C PD.
  • Low power mode



  • The indicator LEDs are too close together to easily read.
  • Passthrough charging works but is fairly slow.  
  • On the pricey side these days, but it is a premium build quality.



The NB10000 is a small, well built powerbank with a great size to performance ratio. It has the features I am looking for in a powerbank in 2020, like PD support, 9 and 12V, and a low power mode. It doesn’t hurt it’s made of carbon fiber too since I am a sucker for it. That said you pay for these more premium features and this isn’t a cheap powerbank.


That said it’s my new travel charger since it’s so easy to put in a pocket and charge on the go. It also fits nicely in my camera bag which is also a plus. The traditional powerbank brands better watch out because Nitecore has them in their sights. 

Pick up The Nitecore NB10000 Carbon Fiber Powerbank at NitecoreStore at